|
1、修改 vi/boot/grub/grub.conf （修改内容为红色标注位置） # grub.conf generated by anaconda # # Note that you do not have to rerun grubafter making changes to this file # NOTICE: You have a /boot partition. Thismeans that # all kernel and initrd paths are relative to /boot/, eg. # root (hd0,0) # kernel /vmlinuz-version ro root=/dev/sda5 # initrd /initrd-[generic-]version.img #boot=/dev/sda default=0 timeout=5 splashimage=(hd0,0)/grub/splash.xpm.gz hiddenmenu serial --unit=0 --speed=115200 --word=8--parity=no --stop=1 title CentOS (2.6.32-431.el6.x86_64) root (hd0,0) kernel /vmlinuz-2.6.32-431.el6.x86_64 roroot=UUID=f0013145-01cc-41ba-b202-0d9b6bc785c7 console=tty0 console=ttyS0,115200 rd_NO_LUKS rd_NO_MDcrashkernel=auto LANG=zh_CN.UTF-8 rd_NO_LVM rd_NO_DM initrd /initramfs-2.6.32-431.el6.x86_64.img 2、修改 vi /etc/inittab（修改内容为红色标注位置） # Default runlevel. The runlevels used are: # 0- halt (Do NOT set initdefault to this) # 1- Single user mode # 2- Multiuser, without NFS (The same as 3, if you do not have networking) # 3- Full multiuser mode # 4- unused # 5- X11 # 6- reboot (Do NOT set initdefault to this) # id:3:initdefault: # Run agetty on COM1/ttyS0 and COM2/ttyS1 s0:2345:respawn:/sbin/agetty -L -f/etc/issueserial 115200 ttyS0 vt102 3、修改vi /etc/securetty(修改内容为红色标注位置) console vc/1 vc/2 vc/3 vc/4 vc/5 vc/6 vc/7 vc/8 vc/9 vc/10 vc/11 tty1 tty2 tty3 tty4 tty5 tty6 tty7 tty8 tty9 tty10 tty11 ttyS0 ttyS1 4、配置完成后，重新启动即可。 (责任编辑：IT) |