1、安装软件 apt-get install ifenslave 2、编辑bonding模块开机自动加载文件 操作系统为Debian Wheezy时,修改/etc/modules文件,添加如下行: bonding max_bonds=2 mode=6 miimon=100 操作系统为Debian Jessie时,新建/etc/modprobe.d/bonding.conf文件,添加如下行: alias bond0 bonding alias bond1 bonding options bonding max_bonds=2 mode=6 miimon=100 3、修改/etc/network/interfaces文件,具体如下,IP可根据实际配置: ############################################################# # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback auto bond0 iface bond0 inet static address 192.168.0.100 netmask 255.255.255.0 gateway 192.168.0.1 post-up ifenslave bond0 eth0 eth2 pre-down ifenslave -d bond0 eth0 eth2 auto bond1 iface bond1 inet static address 192.168.1.100 netmask 255.255.255.0 gateway 192.168.1.1 post-up ifenslave bond1 eth1 eth3 pre-down ifenslave -d bond1 eth1 eth3 ############################################################## ##虚拟网卡绑定模式## 虚拟网卡绑定虚拟网桥配置: auto br0 iface br0 inet static bridge_ports bond0 address 10.80.10.100 netmask 255.255.255.0 gateway 10.80.10.1 auto br1 iface br1 inet static bridge_ports bond1 address 10.80.20.100 netmask 255.255.255.0 gateway 10.80.20.1 auto bond0 iface bond0 inet manual up ip address add 0/0 dev $IFACE up ip link set $IFACE up down ip link set $IFACE down post-up ifenslave bond0 eth0 eth1 pre-down ifenslave -d bond0 eth0 eth1 auto bond1 iface bond1 inet manual up ip address add 0/0 dev $IFACE up ip link set $IFACE up down ip link set $IFACE down post-up ifenslave bond0 eth2 eth3 pre-down ifenslave -d bond0 eth1 eth3 ############################################################## ##以下几行可不添加,多网卡绑定模式下,物理网卡默认为混杂模式## auto eth0 iface eth0 inet manual up ip address add 0/0 dev $IFACE up ip link set $IFACE up down ip link set $IFACE down auto eth1 iface eth1 inet manual up ip address add 0/0 dev $IFACE up ip link set $IFACE up down ip link set $IFACE down auto eth2 iface eth2 inet manual up ip address add 0/0 dev $IFACE up ip link set $IFACE up down ip link set $IFACE down auto eth3 iface eth3 inet manual up ip address add 0/0 dev $IFACE up ip link set $IFACE up down ip link set $IFACE down (责任编辑:IT) |