> CentOS > CentOS故障 >

CentOS系统VMware克隆后重新设置成eth0

问题:用VMware克隆CentOS 6.4后,发现系统内只有eth1,而且/etc/sysconfig/network-scripts/下只有,ifcfg-eth0文件,虽然可以上网,但无法设置静态IP。

ifconfig eth0

eth1: error fetching interface information: Device not found

解决:vi /etc/udev/rules.d/70-persistent-net.rules 显示为:

# PCI device 0x8086:0x100f (e1000)

SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:0c:29:48:85:9c", ATTR{type}=="1", KERNEL=="eth*", NAME="eth1"

将 NAME="eth1" 改成NAME="eth0"

并将 ATTR{address}=="00:0c:29:48:85:9c",中的网卡地址改到

/etc/sysconfig/network-scripts/ifcfg-eth0 文件中,HWADDR="00:0C:29:48:85:9C",使他们对应。

然后reboot

ifconfig eth0

eth0      Link encap:Ethernet  HWaddr 00:0C:29:48:85:9C 

          inet addr:192.168.74.148  Bcast:192.168.74.255  Mask:255.255.255.0

          inet6 addr: fe80::20c:29ff:fe48:859c/64 Scope:Link

          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1

          RX packets:5032 errors:0 dropped:0 overruns:0 frame:0

          TX packets:3674 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:1000

        RX bytes:5762656 (5.4 MiB)  TX bytes:209372 (204.4 KiB)


完成。

(责任编辑:IT)